Conducting Android development without cables using ADB over Wi-Fi enhances productivity and reduces setup friction without the hassle of physical cables. When working with devices in awkward locations, connecting via Wi-Fi saves time and increases mobility. To get started ensuring your Android device and your computer are connected to the identical wireless network. Enable USB debugging in the developer options more info on hackmd your device. Then, plug in your Android via USB and open a terminal or command prompt. Type adb tcpip 5555 to switch the ADB daemon to listen for TCP/IP connections on port 5555. After the system confirms "restarting in TCP mode port 5555", you can safely disconnect the USB cable. Obtain your device’s IP by navigating to Wi-Fi settings and selecting your current network. Then, use the command adb connect [IP]:5555, replacing the device’s local IP with the actual address. If everything is set up correctly, you’ll see successfully connected to [IP]:5555. Perform ADB operations such as shell access, app installation, or log monitoring without a single cable. To validate your Wi-Fi ADB session, use the adb devices command to list all connected devices. If your device appears with the IP address and port you’re good to go. For security, always disconnect from Wi-Fi ADB when you’re done. by running adb disconnect. You can also switch back to USB mode anytime by connecting the device and typing adb usb. Perfect for labs or teams running parallel device tests or when working in environments where cable clutter is an issue. Using wireless ADB, you gain enhanced workflow and convenience while maintaining full control over your Android device.